Grandstream Networks UCM6100 Series Configuration

Firmware Version 1.0.1.25 Configuring UCM6100 Series with HT503 Page 13 of 18
Figure 12: Method 2 - Create Peer SIP Trunk on the UCM6100
Configure Outbound Rule on UCM6100
On the UCM6100 web GUI, go to PBX->Basic/Call Routes->Outbound Routes to create a new
outbound rule. This would allow the extension on the UCM6100 to reach numbers in PSTN network via the
peer SIP trunk we just configured.
Figure 13: Method 2 - Configure Outbound Rule on the UCM6100

Grandstream Networks UCM6100 Series Specifications

General

Brand	Grandstream Networks
Model	UCM6100 Series
Category	PBX
Language	English