Grant Primo User Manual

410
Troubleshooting
My Primo display is showing ‘DRY’
You have started Primo without filling it with water or it has boiled dry during operation. To
reset Primo:
1. Unplug Primo and allow the unit to cool down for 10 minutes.
2. Fill with water and follow the setup instructions on page 7 of this manual.
My Primo display is showing ‘TRIP'
The over temperature protection has tripped because Primo has overheated:
1. Unplug Primo and allow the unit to cool down for 10 minutes.
2. Fill with water and follow the setup instructions on page 7 of this manual.
My Primo display is showing ‘POST’
Primo is still too hot to operate:
1. Unplug Primo and allow it to cool for a further 20 minutes.
2. If the display continues to show ‘POST’ then the unit has been damaged and should be returned
for repair/replacement.
I wish to change the temperature scale
1. Follow the instructions on page 8, titled ‘‘Setting the temperature’’.

Grant Primo Specifications

General

Brand	Grant
Model	Primo
Category	Kitchen Appliances
Language	English