25
4. Clean the tank by rinsing it with a hose through from the top.
5. Refit the drain plug.
6. Reconnect the machine and undo all rinse nozzles.
7. Fill the machine with water through normal procedure.
1. The wash tank is filled through the rinse system.
8. Inspect the rinse nozzles, clean from precipitation and dirt. If
necessary replace.
9. Refit the rinse nozzles.
b. Exchange of rinse pump.
1. Turn off hot water supply and electrical supply.
2. Run the rinse pump using Flashloader software to empty the
rinse tank
3. Empty the last water through the rinse plug. Deflect the water
out of the machine. ( Caution content may be hot. )
4. Perform “Cleaning of rinse system” (section 3/a/4)
5. Undo the hose clamps on the pump.
6. Disconnect the motor at the electrical connector.
7. Undo the 4 screws fastening the pump. Undo the pump.
8. Undo the necessary tube connections on the pump and fit
them on the new pump using suitable thread sealant.
To Next Page
Loading...
