GRAPHTEC CE3000-120 - Page 117

I – 2
Moving the pen while raised or lowered in
response to the “W” command (when the
COMMAND setting is GP-GL) ..................... 5-2
N
NEXT .............................................................. 1-6
O
Optimal cutting conditions for each
media type ................................................... 3-5
Options............................................................A-3
Options and supplies ......................................A-3
ORIGIN ........................................................... 1-6
Origin point.................................................... 4-15
P
Parallel (Centronics) interface
connector .............................................. 1-3, 1-4
Parts names and functions ............................. 1-3
PAUSE............................................................ 1-6
PAUSE menu list ............................................ 4-2
Pen carriage............................................. 1-3, 1-4
Pen holder................................................ 1-3, 1-4
POSITION....................................................... 1-6
Power switch................................................... 1-3
PREV. ............................................................. 1-6
Push rollers .............................................. 1-3, 1-4
Q
Quick start manual .......................................... 1-2
R
Raising and lowering the pen........................ 4-38
Reading range required for the detection of
registration marks ........................................ 4-8
Reference pen conditions for plotting pens..... 3-5
Registration-mark mode.................................. 4-9
Registration-mark pattern................................ 4-7
Registration-mark size .................................. 4-13
Replacing the cutter blade ............................ 2-12
Roll-medium.................................................... 1-2
Roll-medium trays ........................................... 1-3
Roll-medium-tray guide rail ............................. 1-3
Rotating the coordinate axes ........................ 4-27
S
Self-test-pattern printing ................................4-40
Serial (RS-232C) interface connector...... 1-3, 1-4
Setting FORCE ................................................3-7
Setting OFFSET ..............................................3-7
SETTING PRIORITY .......................................5-2
Setting QUALITY .............................................3-8
Setting special functions .......................... 5-4, 5-5
Setting SPEED ................................................3-8
Setting the command mode................... 3-2, 4-32
Setting the cutter-pen ......................................3-5
Setting the cutting/plotting area .....................4-25
Setting the FEED function ...............................4-3
Setting the format of data to be
received .............................................. 3-2, 4-32
Setting the initial cutting position
(origin point)..................................................3-9
Setting the interface conditions........................3-4
Setting the LENGTH UNIT.............................4-48
Setting the OFFSET ANGLE .........................4-45
Setting the OFFSET FORCE
(initial cutting force).....................................4-44
Setting the ORIGIN POINT.................... 3-3, 4-33
Setting the PAGE LENGTH ...........................4-24
Setting the PARALLEL I/F Mode .....................5-3
Setting the PEN UP SPEED ..........................4-43
Setting the registration-mark distance
adjustment ..................................................4-14
Setting the registration-mark pattern .............4-12
Setting the STEP PASS.................................4-46
Setting the STEP SIZE .......................... 3-3, 4-32
Setting TOOL (cutter blade or pen) .................3-6
Sorting ...........................................................4-30
Stand ....................................................... 1-2, 1-5
Stand assembly instructions ............................1-7
Stand construction ...........................................1-7
STATUS...........................................................1-6
Stock rollers ...................................... 1-5, 2-4, 2-5
Stop function..................................................3-10
Stoppers ..........................................................1-5
Storing and selecting cutter-pen-condition
setting areas .................................................3-6
Supplies .......................................................... A-3
T
TANGENTIAL mode ........................................4-5
TEST................................................................1-6