ii
Safety Precautions
WARNING
Do not touch the rollers or moving parts such as the carriage
while cutting or plotting is in progress.
• Such action may result in injury.
Be sure to ground the earth terminal.
• If the cutting plotter is not grounded, the operator could suffer an
electric shock in the event of current leakage.
Keep your hands, hair, etc., away from the rollers or moving
parts such as the carriage even if the cutting plotter is
stopped, as it may suddenly start moving when data is
received.
• Such action may result in injury.
Do not disassemble, repair, or remodel the cutting plotter.
• Such action may cause electric shock or a fire hazard due to
current leakage.
• Contact with the high-voltage parts within the cutting plotter may
cause electric shock.
• If the cutting plotter requires repairs, contact your sales
representative or nearest Graphtec vendor.
Do not connect the cutting plotter to a non-rated power
supply.
• Use of a different supply voltage may result in electric shock or a
fire hazard due to current leakage.
Do not use the cutting plotter in a location where it will be
exposed to water, rain, or snow.
• Such locations may cause electric shock or a fire hazard due to
current leakage.
Do not touch
Ground the cutting plotter
Keep your distance
No disassembly
Specified
rating
Prohibited
Avoid water
Beware of electric shock
To Next Page
Loading...
