GRAPHTEC FC9000-160 - Setting Axis Alignment

13-5
13.3
Adjusting Coordinate Axes
7KHIROORZLQJH[SODLQKRZWRDGMXVWWRFRRUGLQDWHGD[HV
Supplement

After aligning, the alignment will be canceled when the following occurs.
· A new origin point is set.
· The media again is set.
· The Rotation is set. (Please set the Rotation before axis alignment.)
The axis alignment point at this time moves according to the Rotation setting.

:KHQWKHLQFOLQDWLRQRIWKHD[LVLVWRRODUJHLQWKHVWDQGQGSRLQWV$[LV$OLJQPHQW(UURU6HWD[LVDGMXVWPHQWDJDLQPHVVDJHLV
displayed.
 3OHDVHVHWWKHPHGLDDJDLQVRWKDWWKHLQFOLQDWLRQRIWKHPHGLDEHFRPHVVPDOODQGWKHQSHUIRUPWKHDGMXVWPHQWRSHUDWLRQ

If you set the 1st and 2nd points to the same point, the axis alignment will be cleared.
Setting axis alignment
Set to axis alignment mode.
Operation
1
Press the [PAUSE/MENU] key.
MENU screen is displayed.
2
Press the [2] key (AXIS).
AXIS SETTING screen (1/1) is displayed.
3
Press the [2] key (AXIS MODE).
AXIS MODE screen is displayed.