10
Connecting the USB Cable
7
First, make sure that Windows 10 has been launched
successfully.
Next, ensure that the FCX2000 is turned off and then
connect the USB cable supplied with the FCX2000 to
your computer.
(1) Ensure that the Plotter's power is turned off (" " side).
(2) Connect the power cable.
(3) Connect the USB cable.
USB cable
1
.
Connect to your computer.
2. Connect to the
Cutting Plotter.
8
Turn on the FCX2000 unit.
9
Installation of the device starts.
After a while, the printer icon of FCX2000 will be added
in the "Devices and Printers" screen.
* To display the "Devices and Printers" screen, display
the "Control Panel" screen from the Start menu
and then click on the [Devices and Printers] in the
[Hardware and Sound].
This concludes the installation of the driver software.
Next, please install the software applications.
Install the software in accordance with your operating
environment.
Graphtec Pro Studio is the application software that enables
you to create and edit text and graphics.
Installing "Graphtec Pro Studio"
* The computer to be installed must be connected to the
Internet.
* Email address for the account registration is required.
1
Start the browser from the computer, enter "www.
saicloud.com" in the address bar, and then press [Enter]
key.
2
The following screen will be displayed
You can change the display language by selecting the
language at the bottom of the screen.
B. Setup Graphtec Pro Studio
To Next Page
Loading...
