7
Installing the Software
Install the software stored in the attached DVD-ROM into the PC that is used.
This section explains how to install the software when using a Windows 10 (64-bit) operating environment.
•
Upon installation, be sure to log in Windows using an account with administrator privileges on your computer.
If you have logged on using a standard user account, an "User Account Control" screen asking you to enter the administrator account
password may appear.
•
Supported OS
This software supports the following OS environments:
Windows 10 (32-bit/64-bit), Windows 8.1 (32-bit/64-bit), Windows 8 (32-bit/64-bit ), Windows 7 (32-bit/64-bit )
(Plotter driver also supports Windows Vista.)
Mac OS X 10.11 to 10.7
(Graphtec Studio also supports Mac OSX 10.6.)
•
When Using Macintosh
Macintosh operating environments are supported by the following software.
Proceed with installation in accordance with your operating environment.
• Graphtec Studio : Software application that enables cutting data to be created through simple commands.
• Cutting Master 4 : Plug-in driver that can be directly operated from within Adobe Illustrator.
Note that Adobe Illustrator must be installed on your computer prior to use.
When checking the manual in the Macintosh operating environment, open the pertinent manual on the accompanying DVD-ROM in the
following sequence: [Manuals] > [English] > [Manual According to Software].
•
Setup in a Windows operating environment
Launching the Start Menu
After starting up Windows, insert the [USER GUIDE & SOFTWARE DVD] supplied with the FCX2000 into your computer's DVD
drive.
The below screen will appear before the Start Menu launches.
Continue with installation in accordance with the following procedures.
1
The start-up message of DVD drive is displayed. Click on the message.
* When setting up the DVD in the computer, this message will disappear after a few seconds.
2
DVD operation screen is displayed.
Select the “Run MultiSetup.exe” from the DVD operation screen.
* If the DVD operation screen is not displayed, select the set DVD drive from the Explorer.
Then, select the “MultiSetup.exe” in the DVD and double-click on it.
To Next Page
Loading...
