8
Supplement
If you have logged in using a standard user
account, an "User Account Control" screen asking
you to enter the administrator account password
may appear. Enter the password, and then click on
[Yes].
3
The [User Account Control] screen is displayed.
Click on [Yes] if you have logged in using an administrator account.
4
The [Start] screen will appear.
Use this menu to install the software you require to use the FCX2000.
First-time users should proceed with installation by clicking on [Install FCX2000 Software].
Proceed with installation according to your operating environment.
A
B
C
D
A. Install FCX2000 Software:
Install the [Plotter Driver].
B. Setup Graphtec Pro Studio:
"Software enabling cutting data to be created through simple commands.
Create designs and edit characters/shapes using this software."
C. Setup Cutting Master 4:
Plug-in driver that enables simple cutting through direct operation from
within Adobe Illustrator and CorelDRAW.
Adobe Illustrator or CorelDRAW must be installed on your computer prior to
use.
D. Install User's Manual:
Installs the FCX2000 User's Manual.
To Next Page
Loading...
