3
Setting up the Plotter main unit
1 Attaching a Tool
Attach a tool to the plotter.
Attaching a Tool
When attaching the tool in the tool holder, please note the following.
• Push the tool all the way into the holder until its ange contacts the upper part of the holder and then tighten the screw rmly.
• To prevent injury, avoid absolutely touching the tool immediately after the cutting plotter is turned on or whenever the tool is
moving.
For details, see “Attaching a Tool” in the FCX2000 User’s Manual.
It is explained here using cutter plunger as an example.
CAUTION
When pushing up the tool holder with your ngers, the blade tip may be protruding. Take care not to cut your ngers.
1
Loosen the tool holder screw.
1
2
Tool holder
Bracket to hold tool
CAUTION
When pushing up the tool holder with your
ngers, the blade tip may be protruding. Take
care not to cut your ngers.
2
While pushing up the tool holder, push until its ange completely touches
the upper part of the holder.
1
2
Bracket to hold tool
Flange
Tool holder
To Next Page
Loading...
