4
3
Make sure that the tool bracket is engaged on the tool's ange, and then tighten the screw.
1
2
Flange Bracket to hold tool
Removing the tool
When removing the tool, turn it counterclockwise to remove the tool.
2 Loading the Media
Supplement
• This plotter is available with a vacuum suction writing panel, a electrostatic writing panel, or an magnetic writing panel.
Note that the media is loaded differently depending on the media hold-down method.
• There are media that cannot be held down by any method. Please test before use.
• Antistatic-treated media cannot be held down in electrostatic writing panel.
• If air gets in between the writing panel and the media during loading, force out the air and ensure that the media is
securely attached to the writing panel before cutting.
• When cutting a media that doesn’t come with a backing sheet on the electrostatic writing panel/magnetic writing panel,
spread a vinyl backing sheet or something similar on the panel before cutting. Replacement of damaged lighting panel
is available for a fee.
• When loading a media that cannot be securely attached using the normal hold-down method, reinforce adhesion by
using tape on all four sides.
• When using the electrostatic writing panel, do not use a spray glue and a spray glue remover directly on the writing
panel.
• When the media is changed to a different type, we recommend that you perform the registration mark sensor
sensitivity adjustment. (See “Setting the Registration Mark Detection Judgment Level” in the User's Manual (PDF).)
Vacuum suction
(1) Place the media on the writing panel.
(2) Turn on the blower's power supply.
Supplement
• The blower is not supplied as a standard accessory. It must be purchased separately.
Electrostatic adhesion
(1) Make sure that the [CHART HOLD] key is turned off.
(2) Place the media on the writing panel.
(3) Press the [CHART HOLD] key (to hold-down the media) next to the control panel.
(4) The green [CHART HOLD] key lamp (to hold-down the media) lights to indicate that the media is being held by electrostatic
adhesion.
To Next Page
Loading...
