GRAPHTEC GL400 - Monitor Part Names and Functions (GL400)

2-4
Checks and Preparation
2.4 Monitor Part Names and Functions (GL400)
This section describes the monitor unit on top of the GL400.
Simplified message
display area
Processing mode
display area
Time/Div
display area
Key lock Battery drive
Remote
AC drive
Date/Time display area
Alarm display area
Monitor area
Logic display area
Pulse display area
Waveform/settings window display area
Pen display
Scale upper limit value
Scale lower limit value
Processing mode display area
.................................. Displays the processing mode currently set
Simplified message display area
.................................. Displays the system status. ("Free Running") is usually displayed. For
example, "Armed" is displayed when waiting for a trigger signal.
Time/Div display area ......... Displays the current time scale.
Date/Time display area ....... Displays the current date and time.
Monitor area........................ Displays the input signal values for each channel.
Waveform settings/window display area
.................................. Displays the measurement signal waveforms. The menu windows are
also displayed when the condition setting keys are pressed.
Scale upper limit/lower limit
.................................. Displays the measurement scale for the range set.
Key lock .............................. Lit when the GL400 is in key lock status. To enable key lock status,
hold down the [ ] [ ] key for at least three seconds.
Remote ............................... Lit when the GL400 is in remote status
AC drive .............................. Lit when the AC is in use.
Battery drive........................ Lit when the battery is in use.
Pulse display area .............. Displays the measured values.
Logic display area............... Displays the action status.
Pen display ......................... Pens are displayed for each group.