Checks and Preparation
2-7
2.7
Connecting the Power Cable and Turning on the Power
This section describes how to connect the power cable and turn on the power. The connection method will
vary depending on the type of power supply used.
Connecting to an AC Power Supply
Use the AC cable and AC adapter that are provided as accessories.
(1) Plug the AC cable into the AC adapter.
AC adapter
AC cable
(2) Connect the output side of the AC adapter to the connector on the GL400/350.
(3) Using the screwdriver provided as a standard accessory, press against the button underneath
the ground terminal while connecting the grounding cable to the GL400/350. Connect the other
end of the cable to ground.
Grounding cable
(4) Plug the AC cable into the mains power outlet.
(5) Press the power switch on the GL400/350 to the ON side to turn on the power.
CAUTION
Always connect the GND terminal and refer to the safety precautions. The GL400/350 must be
grounded even when connected to other devices and sharing a common ground level.
To Next Page
Loading...