GRAPHTEC GL400 - Connecting to a DC Power Supply

2-8
Checks and Preparation
Connecting to a DC Power Supply
Use the optional DC drive cable (B-514).
CAUTION
Use a power supply within the 8 to 24 VDC range.
(1) Configure the tip of the DC drive cable (B-514: 2m) to enable it to be connected to the DC
power supply.
(2) Connect the DC output side to the power supply connector on the GL400/350.
B-514
8 to 24 VDC power supply
Shielded lead (– side)
White (+ side)
(3) Connect the DC input side to the DC power supply.
(4) Press the power switch on the GL400/350 to the ON side to turn on the power.