4-14
Software
4.8 Measurement Parameters Settings
Click the "Settings" button on the main menu to enable device and measurement parameters for the GL400/
350 to be made.
CHECKPOINT
The GL400/350 settings are changed whenever the "OK" or "Apply" button is clicked in each setting menu.
AMP Settings
(1) Select CH
Specify a group or groups of channels in the range [1 to 10] through [91 to 100].
Analog AMP Settings:
• Line Color: Specifies the color for each channel.
• Annotation: Up to 11 characters can be input for each channel.
CAUTION
Certain characters used here may not be displayable on the GL400 monitor.
• Input: OFF, DC, Temp
Sets the input type for each channel.
• Range
DC: 20, 50, 100, 200, 500 mV, 1, 2, 5, 10, 20, 50 V
CHECKPOINT
For the 1-5V range, select 5V, and then specify 5V for the upper span limit and 1V for the lower
span limit.
Temp: Specify one of the following:
TC-K, TC-J, TC-T, TC-E, TC-B, TC-R, TC-S, TC-N, TC-W, Pt100, JPt100.
• Filter: Off, On
Select On if you need to cut noise.
• Unit: The measurement unit is displayed during measurement.
All CH: Sets the Input, Range, and Filter values to the same values for all the channels in the
displayed group. Click the "Set" button next to "All CH" to make the settings.
To Next Page
Loading...