Software
4-21
Trigger
The trigger Start/Stop settings are made here.
(1) Trigger Settings
Start
• Function: Sets the Data Capture Start condition.
Off: No trigger is used. Instead, measurement is initiated by pressing the
START/STOP key.
Level: The start of measurement is triggered when the trigger condition is
satisfied.
Alarm: The start of measurement is triggered with the alarm condition is
satisfied.
External: The start of measurement is triggered when a signal is input from an
external trigger terminal.
• Alarm Output: Selects the alarm output when the Function is Alarm.
Stop
• Function: Sets the Data Capture Stop condition.
Off: No trigger is used. Instead, measurement is stopped by pressing the
START/STOP key.
Level: Measurement is stopped when the trigger condition is satisfied.
Alarm: Measurement is stopped when the alarm condition is satisfied.
External: Measurement is stopped when a signal is input from an external trigger
terminal.
Time: Sets the amount of time from the start until the end of measurement. (The
time can be specified in 1- second increments).
Alarm Output: Selects the alarm output when the Function is Alarm.
Time: Sets the end time when "Function" and "Time" have been set.
To Next Page
Loading...