Software
4-13
4.7 PC Connection Settings
The GL400/350 can be connected to a computer via USB or TCP-IP (LAN).
(1) Click the "Connect" button on the main menu to display the Connect window.
Select USB or TCP-IP.
(2) Edit
Several settings need to be made to enable connection to your PC.
No.: Select a number from 1 to 10. When a number is selected, a submenu
(settings list) appears.
Name: Enter a name for device control (any name).
IP Address: Set the IP address for the GL400/350 connected (when using network).
Port: Set the port number for the GL400/350 connected (when using network)
USB ID: Set the ID number for the GL400/350 connected (when using the USB
interface)
Group: When two or more GL400/350 devices are being used for simultaneous
measurement, register them in the same group. This setting must be made
for simultaneous measurement.
When all the settings have been made, click the "OK" button to complete the setting operation.
(3) Connect, Disconnect/Load Conditions, Save Conditions
Connect: Click the "Connect" button to connect the GL400/350 to the computer when
all the settings have been made.
Disconnect: Click this button to cancel the Connect status. If the GL400/350 is not
connected and this button is clicked, the "Device not connected" message
will appear on the screen.
Load Conditions:Click this button to load previously-saved settings and enable changes to be
made if required.
Save Conditions:Click this button to save the settings. Please specify the file name and save
destination. The file name will have a .cfg extension.
To Next Page
Loading...