Settings and Measurement
3-23
Trigger level settings/Alarm level settings
Mode ................................... Specifies mode trigger/alarm output conditions.
Off: Does not enable trigger/alarm.
H: A trigger/alarm is generated when the signal input rises to (or
exceeds) the specified level.
L: A trigger/alarm is generated when the signal input falls to (or falls
below) the specified level.
Win In: Used to specify the upper and lower limits for each channel.
When the signal level goes within (or is within) either limit, a trigger/
alarm is generated.
Win Out: Used to specify the upper and lower limits for each channel.
When the signal level goes outside (or is outside) either limit, a trigger/
alarm is generated.
CH.1
Measurement starts (alarm generated)
CH.1
Measurement starts (alarm generated)
CH.1
Measurement starts (alarm generated)
CH.1
Measurement starts (alarm generated)
To Next Page
Loading...
