Settings and Measurement
3-27
Interface settings
This menu is used to specify conditions for PC connection.
New Line code .................... Specifies the line feed code.
CR+LF :Starts a new line with CR+LF code (default value).
LF :Starts a new line with LF code.
CR :Starts a new line with CR code.
USB .................................... Specify settings relative to USB interface.
• USB ID :Sets the USB ID number of GL800.
Specify a number from 0 to 9 (default value: 0).
TCP-IP ................................ Specify TCP-IP settings of GL800.
• IP address : Specifies the IP address.
Default value (192.168.0.1)
• Subnet mask : Sets the subnet mask.
Default value (255.255.255.0)
• Port number : Sets the port number.
Specify a value from 1024 to 65535.
Default value (8023)
• Gateway : Sets the gateway address.
Default value (0.0.0.0)
CAUTION
You must restart GL800 when any change is made to an interface setting value.
If you continue to operate GL800 without restarting after these changes, the new setting values will not
be applied. As a result, the GL800 will not be able to establish a connection to your PC.
Settings Selections available
New Line code CR+LF, LF, CR
USB ID 0 to 9
IP address Numerical value
Subnet mask Numerical value
Port number Numerical value
Gateway Numerical value
To Next Page
Loading...
