14 Creative Grading Camera Control System User’s Guide (v1.4)
Chapter 2 - Installation
Tap OK. The Settings page opens. Go to the IP address and enter the IP settings you copied or
noted from the CCS-ONE.
2.4 Installing the CGP Creative Grading Panel
2.4.1 Connecting power
Follow these steps to install a panel for first-time use:
• Attach the Ethernet cable to the Ethernet connector on the back side of the CGP and
connect it to the Ethernet switch (make sure it is connected to the C2IP Ethernet port of
the CCS-ONE).
• If the Ethernet network is not powered connect power to the panel.
2.4.2 Setting up the network
• After applying power to the CGP wait a few seconds for the panel to start up. The Creative
Grading logo is shown on the display during the start-up procedure.
• The CGP’s IP configuration mode is set to AutoIP mode by default and it automatically
connects to the CCS-ONE server.
• Check if the panel is connected to the network.
To Next Page
Loading...