31 / 44
16570.16572_Alpha150Q/170Q/220Q_V1
ശ In Attitude mode, when the selected switch is activated,
the channel 6 bar must exceed the minimum value of
+110%.
ശ In the Rate mode, the bar of channel 6 must remain at 0%
even if the selected switch is pressed.
So programmed, the auto-flip function can be "armed" in the
Attitude mode with a short change of the self-resetting switch for
about 5 seconds. As soon as the roll or pitch control stick is moved
more than 50% of its way within this time, the copter will auto-
matically flip to the appropriate direction.
Note
After the flip, position deviations in the range of <10 ° are pos-
sible.
"Telemetry" menu
SETTING & DATA VIEW
Telemetry
SETTING & DATA VIEW
SENSOR
RF STATUS VIEW
VOICE TRIGGER
RX DATA ON
ALARM SETTING
The basic handling of the "Telemetry" menu is described in the man-
ual of the respective HoTT transmitter with display. By way of dero-
gation, only in certain receivers the menu structure is summarized
under the generic term "setting & data view". These instructions
also provide information on how to access this menu. Change accord-
ingly to the first setting page of the receiver module of the 3D or
Race copter Alpha 150Q, 170Q or Race copter Alpha 220Q.
Note
The setting values shown in the following display illustrations show
the respective default values of the copters mentioned above.
Receiver display
LANGUAGE
In the "Language" line you can set the display language in the receiver
menu.
The choices are: German, English, French, Italian, Spanish
ALARM VOLT
If the receiver voltage falls below the set value, a low-voltage warn-
ing is generated by the transmitter in the form of a "sound-declining
RECEIVER Q.06
ALARM VOLT: 10.2V
ALARM TEMP: 70°C
VIDEO CHANNEL R3
ALARM CAPAC. 1200mAh
LANGUAGE: English
K5: SERVO
RECEIVER Q.06
ALARM VOLT: 10.2V
ALARM TEMP: 70°C
VIDEO CHANNEL R3
ALARM CAPAC. 600mAh
LANGUAGE: English
K5: SERVO
To Next Page
Loading...
Need help?
General
