35 / 44
16570.16572_Alpha150Q/170Q/220Q_V1
YAW DYNAMIC
Higher dynamic values provide a more direct feel for the flight (3D
flight 80 ... 100), lower dynamic values for smoother flight record-
ings, rounder freestyle flying and races (30 ... 80).
Multicopter Basis display
TYPE
The "Type" line defines the basic configuration of the copter. The fol-
lowing selections are available: "Quadro X", "Quadro XI" and "Quadro
+". The default setting "Quadro XI" is, however, to be maintained,
otherwise the copter will become uncontrollable.
ESC
This term is composed of the first letters of the English term "Elec-
tronic Speed Control" as a synonym for "motor control". In this line,
therefore, the type of the installed motor control must be entered
de facto. This value is, like the previous "type", given by the facto-
ry-installed technique of the copter and therefore may not be
changed at will.
MODE
NORMAL
This setting must be used for copters with speed controller without
reverse of the direction of rotation.
ACRO 3D
This setting is reserved for copters whose speed controllers are
equipped with direction reverse.
Attention
The setting ACRO 3D is reserved for the 3D copter Alpha 170Q No.
16570.HoTT.
Note
For safety reason the "Type" and "Mode" changes take effect after
switching off and on the receiver system.
MULTICOPTER BASIC
FREESTYLE 1
MINPOWER % 10
CALIBR.POSITION NO
KALIBR.LAGE NEIN
ESC S3087
TYPE QUADRO XI
MODE NORMAL
MULTICOPTER BASIC
FREESTYLE 1
MINPOWER % 5
CALIBR.POSITION NO
KALIBR.LAGE NEIN
ESC S3088
TYPE QUADRO XI
MODE NORMAL
MULTICOPTER BASIC
FREESTYLE 1
MINPOWER % 15
CALIBR.POSITION NO
KALIBR.LAGE NEIN
ESC S3087
TYPE QUADRO XI
MODE ACRO 3D
To Next Page
Loading...