19 / 28
S1005_S1006_jp_V1
Control sticks length adjustment
Length of both control stick can be adjusted. Hold down the
bottom half of the knurled grip, and loosen the screwed connec-
tion by turning the top part:
You can now lengthen or shorten the control stick by screwing
it up or down. Then clamp the top and bottom part of the grip
by rotating them against each other.
Transmitter power supply
Low voltage warning
The transmitter battery voltage should be monitored in the LCD
display during operation. Once the adjustable voltage in the
"battery warning threshold" is reached in the "Etc.Set" submenu
of the system menu,Seite 202, a standard 4.8 V (NiMH) for the
mz-18 HoTT transmitter and 3.6 V (lith.) for the mz-24 HoTT
transmitter, a warning beep sounds, and the following window
appears in the display:
Now at the latest, stop operation and recharge the transmitter
battery!
Binding
Explications about the binding process can be found in
the Part 2 of the manual.
For a transmitter commissioning the receiver must be bound to
the transmitter. This binding process is necessary for the opera-
tion of the model!
The exact sequence of the binding operation is described in the
section “Binding” in the Part 2 of the manual and in the respec-
tive receiver manual. Note: The procedure will be different for the
different receiver types.
Charging the transmitter battery
WARNING
Protect the charger from dust, dirt, moisture, vibrations and
other foreign parts.
The charger should always be supervised during charge and
it should be used only in rooms fitted with a smoke detector.
The charger and the battery to be charged must be placed
on a non-combustible, heat-resistant and non-conducting
surface during operation. Do not use the charger near easily
flammable materials.
Verify if the charger is suitable for your battery type.
Always connect only one battery to the battery charger out-
put.
Use only batteries and battery cables with suitable connec-
RÜCK
CLR
EIN
S. VOLT
04
3.5V
NEU LADEN
E. VOLT
00
3.7V
FELD ST.
00
000%
ESC STR
00
000.0A
ESC VOLT
00
00.0V
ALARM FELD ST.
EIN
To Next Page
Loading...
Need help?
General
