First contact
L-SOLUTION 700 / 800 / 900 machines . 101
8. Select the TICKLE menu using the arrows keys
SET LASER TYPE
TICKLE
RE-ALIGN MACHINE
9. Validate
The green indicator light is flashing and the red indicator light is on : This parameter is protected.
Do not use the controls or settings and do not carry out procedures other than those
specified in the use manual, to avoid risking exposure to dangerous radiation.
10. To modify this "Tickle" parameter, press simultaneously these keys
TICKLE
(0=OFF)
11. Select the number of the correct engraved line using the arrows keys
TICKLE 4
(0=OFF)
If Tickle=0, the LASER source use the tickle value defined in factory.
12. Validate
<READY TO RECEIVE>
001 FILENAME1
PUI 40 VIT 10
DPIX 400 DPIY 400
Tickle adjustment
To Next Page
Loading...
