GRAVOGRAPH L-Solution 800 - Air Assist Function

First contact L-SOLUTION 700 / 800 / 900 machines . 53
Air assist
(pict. 2 and 3)
Air flow is in the same direction as engraving. It is used to clean and extinguish flames that may be produced
on some materials.
To activate this function you must first make sure that the air assistant is connected to a compressor (optional) (see "Air
assistant requirements" in the "Installation" chapter).
To adjust the air flow use the button on the right of the control panel (see "Front view of the machine" in the "Description"
chapter).
It needs to be set for each colour. Once activated, an asterisk appears on the line of the specific colour (pict. 3).
Printer driver