Gree GFH09K3FI - Page 125

122
U-Match Series DC
Inverter Service Manual
Disassembly of panel parts
Remark: Make sure the power supply is cut off before disassembling and protect all
the parts during disassembly. Do not scratch the outer parts.
Step Illustration Handling Instruction
Disassembly of panel parts
Unscrew the 3 sides’ screws on the
cover to remove the cover.
Disassembly of sub-assy of electric box
Remark: Make sure that the power supply is cut off before disassembling and protect all the parts
during disassembly, especially the components inside the box in case of water and hit.
Step Illustration Handling Instruction
1. Disassembly of
electric box cover
Disassemble 3 screws as shown by the arrow in the
graph on left and remove the electric box cover.
'LVDVVHPEO\RIDLUGHÀHFWLQJSODWHPRGXOHV
Remark: Make sure the power supply is cut off before disassembling and protect all the
SDUWVGXULQJGLVDVVHPEO\HVSHFLDOO\WKHMRLQWVRIWKHDLUGHÀHFWLQJSODWH
Step Illustration Handling Instruction
Disassembly of sub-assy
RIDLUGHÀHFWLQJSODWH
5HPRYHWKHDLUGHÀHFWLQJSODWHVIURPWKHDLU
GHÀHFWLQJSODWHVXSSRUWDVVHPEO\DQGWKHQUHPRYH
both ends from the air sweeping motor. joint (As is
shown in the graph, arrow represents the support
assembly and circle the air sweeping motor joint.)
Disassemble of water-containing plate modules
Remark: Make sure the power supply is cut off before disassembling and protect all the parts during disassembly.
Step Illustration Handling Instruction
Disassemble of water-
containing plate modules
Remove the water-containing plate modules.
Disassembly of evaporator components
Remark: Make sure that the power supply is cut off and protect the copper tube and aluminum
¿Q,IWKHWLPHIRUGLVDVVHPEO\VKDOOEHORQJVHDOWKHFRSSHUWXEH
Step Illustration Handling Instruction
Disassembly of
evaporator components
Unscrew the 6 screws of evaporator, 3 screws
of water groove press board and the 2 screws
of water board to remove the evaporator.