Owner’s Manual
16
4.2 Commissioning
4.2.1 Set Master Indoor Unit
Under Off status, long press “MODE” button for 5s to set the
corresponding indoor unit of wired controller as master indoor unit. If
the system mode priority is the master-slave mode, “ ” icon will be
light after finishing setting.
NOTES:
① There is a master indoor unit in a system, other slave indoor units
can be set as master unit, in which case, the original master unit
will become a slave unit.
② This function is not applicable to partial units.
4.2.2 Parameter Enquiry
Unit parameters can be checked in unit On or Off status.
(1) Long press “FUNCTION” button for 5s to enter the
interface of viewing unit parameters. “C00” is displayed in
temperature zone.
(2) Press “+” or “-” button to select parameter code.
(3) Press “ENTER” button to return to last step until exits
viewing parameters.
The parameter enquiry list is as following:
To Next Page
Loading...
