Owner’s Manual
35
the setting temperature be adjusted by pressing “+” or “-” under
Auto mode.
② When Absence function is activated, the setting temperature
cannot be adjusted by pressing “+” or “-”.
③ When the wired controller is connected with a Fresh Air Indoor
Unit, fresh air indoor unit code “FAP” will be displayed as shown
below. Setting temperature won’t be displayed and can’t be
adjusted via “+” or “-” button. The air outlet temperature in cooling
or heating can only be set in the parameter setting status.
5.4 Fan Setting
(1) Under On status, pressing “FAN” button can set fan speed
circularly as:
(2) Turbo function setting
In unit on status, press “FUNCTION” button to switch to Turbo
function with Turbo function icon “ ” blinking, and then press
“ENTER” button to start or cancel Turbo function.
To Next Page
Loading...
