Owner’s Manual
24
(1) Long press “FUNCTION” button for 5s and the temperature
zone displays “C00”; long press “FUNCTION” button for
another 5s to enter the interface of setting wired controller
parameters. “P00” is displayed in temperature zone;
(2) Press “+” or “-” button to select parameter code. Press
“MODE” button to enter parameter setting. At that time,
parameter value is blinking. Press “+” or “-” button to adjust
the parameter value and press “ENTER” button to finish
setting.
(3) Press “ENTER” button to return to last step until exists
setting parameters.
The parameter setting list is as following:
Table 4.2 Parameter setting list
Parameter
code
Parameter
range
value
Note
P10
Set master
indoor unit*
00: do not
change current
master/slave
state
01: set current
indoor unit as
master indoor
unit
00
When set the
corresponding indoor
unit of wired controller
as master indoor unit,
the “ ” icon will be
bright after finishing
setting.
NOTE:
not applicable
to partial units.
To Next Page
Loading...
