Wired Controller XK46
16
after finishing setting.
Note:
① There is a master indoor unit in a system, other slave indoor units can be set
as master unit, in which case, the original master unit will become a slave
unit.
② In one system, only one set of master indoor unit is allowed. If system detects
that there are several master units, it will designate the unit with the smallest
project number as a master unit.
3.2.2 Parameter Enquiry
Unit parameters can be checked in unit On or Off status.
(1) Long press “FUNCTION” button for 5s to enter the interface of viewing unit
parameters. “C00” is displayed in temperature zone and “CHECK” icon is light;
(2) Press “ ” or “ ” button to select parameter code;
(3) Press “ENTER/CANCEL” button to return to last step until exits viewing
parameters.
The parameter enquiry list is as following:
Table 3.1 Parameters viewing list
Entrance of
adjustable
parameter
In “C00” status, Timer zone shows the current
indoor unit project number. When one wired
controller is controlling multiple indoor units,
then only the smallest project number will be
displayed.
Copyright 2018. This translation is property of GREE PRODUCTS SL. All rights reserved. Total or partial reproduction without its express authorization is prohibited.
To Next Page
Loading...
