Wired Controller XK46
21
OR
Note:
① the available modes are different for different models, the wired controller will
automatically select mode setting range according to the model of indoor unit.
② The Auto mode can be only set at the master indoor unit.
③ Under Auto mode, if the indoor unit is running under Cooling, the icons“ ” and
“ ” will light up; if the indoor unit is running under Heating, the icons“ ” and
“ ” will light up.
3.3 TEMPERATURE SETTING
Pressing “ ” or “ ” button in On status increases or decreases set temperature
by 1°C; holding “ ” or “ ” button increases or decreases set temperature by 1°C
every 0.3s.
In Cooling, Fan, Heating, Floor Heating, 3D Heating or Space Heating mode,
temperature setting range is 16°C~30°C.
In Dry mode, the temperature setting range is 12°C, 16°C~30°C. In Dry mode,
when temperature is 16°C, continuously press “ ” button twice to decrease
temperature to 12°C (when save function is activated, the temperature in Dry mode
can’t be adjusted to 12°C and the setting range is “lowest temperature in Save mode” ~
30°C).
Note:
① Under Auto mode or Out function is activated, the setting temperature can not be
adjusted by pressing “ ” or “ ”.
② When the wired controller is connected with a Fresh Air Indoor Unit, fresh air
indoor unit code “FAP” will be displayed as shown below. Setting temperature
won’t be displayed and can’t be adjusted via “ ” or “ ” button. The air outlet
temperature in cooling or heating can only be set in the parameter setting status.
Copyright 2018. This translation is property of GREE PRODUCTS SL. All rights reserved. Total or partial reproduction without its express authorization is prohibited.
To Next Page
Loading...
