Wired Controller XK46
51
Fig.4.16 Save Setting for Cooling in Fahrenheit
Save Setting for Heating: When unit is on and under Heating, 3D Heating and
Space Heating modes, press FUNCTION button to select Save function. “ ” icon
will blink and MAX icon lit up. Press “ ” or “ ” button to adjust the MAXIMUM
temperature. Press ENTER/CANCEL button to turn on this function.
Turn off Save Function: Press FUNCTION button and select Save function.
“ ” icon blinks. Then press ENTER/CANCEL button to cancel this setting.
Note: When the Save function is turned on and then set temperature exceeds
the limit value for Save function, “ ” icon blinks three times and then buzzer will
give out two sounds successively.
Copyright 2018. This translation is property of GREE PRODUCTS SL. All rights reserved. Total or partial reproduction without its express authorization is prohibited.
To Next Page
Loading...
