Printed in the U.S.A.
Greenlee Textron / Subsidiary of Textron Inc.
4455 Boeing Drive, Rockford, IL 61109-2988 USA
Customer Service (International): 815/397-7070 • Fax: 815/397-9247
Customer Service (North America): 800/435-0786 • Fax: 800/451-2632, 815/397-1865
Canada Fax: 800/524-2853
Troubleshooting
PROBLEM PROBABLE CAUSE POSSIBLE REMEDY
Bender will not operate. No voltage. Check supply voltage circuit operation.
Check that switch is on.
Bends are overbent a few Pointer is adjusted wrong. Loosen pointer locking screws and
degrees. rotate clockwise to compensate.
Retighten locking screws.
Too much squeeze on 1-1/4", 1-1/2" Back squeeze off per adjustment
or 2" EMT, IMC or Rigid Aluminum instructions.
conduit.
Unusual conduit characteristics. Bend smaller angle to compensate.
Bends are underbent a few Pointer is adjusted wrong. Loosen pointer locking screws and
degrees. rotate counterclockwise to compen-
sate. Retighten locking screws.
Too little squeeze on 1-1/4", 1-1/2" Increase squeeze per adjustment
or 2" EMT, IMC or Rigid Aluminum instructions.
conduit.
Unusual conduit characteristics. Bend larger angle to compensate.
To Previous Page
Loading...
