Greenlee Textron / Subsidiary of Textron Inc.
8
4455 Boeing Dr., Rockford, IL 61109-2988 815/397-7070
853 Quad Bender™
Setup
Unplug the bender before changing accessories.
Accidental start-up can result in serious injury.
Wear eye protection when operating
or servicing this tool.
Failure to wear eye protection can
result in serious eye injury from
flying debris.
Roller Support Assembly Installed
3. Place the bender in either the vertical or horizontal
bending position.
2. Slide the bending shoe onto the shaft of the main
sprocket, as shown. Align the four drive studs on
the back of the shoe with the four holes in the main
sprocket.
Installing a Bending Shoe
Install pin
1. Mount the support unit onto the leg of the bender.
Install left side of Roller Support Assembly on left
leg of bender first then lower right side of Roller
Support Assembly onto right leg. Install the hinge
pin, as shown.
Some bender parts and accessories are heavy and
may require more than one person to lift and
assemble.
Failure to observe these precautions can result in
injury or property damage.
To Next Page
Loading...
