EasyManua.ls Logo

Grill'D Aurora - Heater operation

Grill'D Aurora
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
39
thus ensuring maximum heang of the steam room;
closely laid stones prevent convecon and provide maximum protecon from infrared
radiaon.
IMPORTANT! It is prohibited to use halite to ll stone heaters.
2.6. Heater operation
IMPORTANT! Before each heang up of the heater, make sure that there are no foreign
objects in the rebox, ash drawer or in the chimney, and that there is chimney dra.
1. Remove all unnecessary and foreign objects from the rebox and chimney, remove ash
from the ash box.
2. Put 3-4 logs on the grate in such a way as to ensure free access of air to the combuson
area, namely: lay the rewood loosely, adjust the ash drawer gap to be within 50 mm
3. Ignite the fi ewood loaded into the rebox. The preferred ignion method is using
birch bark, wood chips and other natural materials, or using paper or throwaway
newspapers.
4. Close the door.
5. Partly close the ash drawer aer heang up of the chimney and development of
stable dra (usually aer burning of the rst load of rewood, approximately in 30-45
minutes), leaving a gap within 10 mm. It is necessary to constantly ensure sucient
dra, while avoiding the development of excessive one (it can manifest itself as
humming of the heater, too errac ame), that leads to heang of the rebox red hot,
which signicantly reduces the heater service life. Control the dra by adjusng the ash
drawer gap.
6. Close the ash drawer completely aer the air in the bath house heats up to a
temperature of 60-70 °C.
7. As a rule, 1-2 logs are enough to maintain the temperature in the steam room. In case
the temperature decreases, open the ash drawer and adjust the gap within 3-10 mm in
order to kindle the rewood (it takes more me, when the ash drawer is closed), and
close the ash drawer aerwards. If the temperature keeps decreasing, then adjust the
ash drawer gap within 3-10 mm and keep it unl the temperature reaches 60-70 °C,
then close the ash drawer. Bear in mind, that excessive heang (for example, several
full loads in a row) leads to overheang and shortens the heater and chimney service
life, and can also cause a re.
8.
When additional firewood is required, open the door smoothly, without jerks. Load the
firewood and close the door. Adjust the draft.
9. Aer the compleon of bathing procedures prepare the room and the heater for
closing: they are to be aired and dried. To do so:
Put 4-5 logs into the heater rebox, kindle them. Set the ash drawer gap to be
approximately 10 mm. Open the hatches/windows, that serve for airing, and the door
in order to develop a small dra.
Note: the air and the bath house to remain heated, the air to move barely noceably,
i.e. it shall be quite warm and even hot in the bath house (up to 60-70 °C).
Heat up the bath house in this mode, the rewood will burn in approximately 30-45
minutes. Completely close the ash drawer aer formaon of acve red coals. Close the
hatches/windows and the door, leave the bath house unl next use.
The room and the heater to be periodically checked aer such stokings: there shall be

Table of Contents

Related product manuals