Grill'D Aurora - Typical faults and troubleshooting methods

41
Procedure in case of fire in the chimney:
1. Close the door, the ash drawer, and the ue damper (if available).
2. Call the local re department.
3. Do not aempt to exnguish the re with water.
4. Aer an ignion of soot, a specialist shall check the heater and the chimney for the
possibility of further operaon.
IMPORTANT! The use of cleaning log (briquees), homemade compounds creang high
temperature in the heater rebox and chimney, is prohibited for the purposes of burning
the soot deposited in them.
The stones deteriorate with me as the heater is operated, this is why it is necessary to
turn them over and reposion in the stone heater at least once a year, when the heater is
frequently operated. Remove the destroyed stones and their parts from the stone heater,
replace them with new ones. Before laying the stones, clean the heater with a wet cloth.
The ash drawer shall be cleaned at all mes before heang, so that the combuson air
passing through the ash drawer to cool the grate, thereby increasing its service life. If there
is a thermal glass door, use so cleaning waste with special agents for cleaning heat-
resistant glass of replaces and heaters in accordance with the applicaon instrucons.
Please, obey re safety rules!
2.9. Typical faults and troubleshooting methods
1) Fault: Odors appear during the heater operaon.
Possible cause:
• There is leover industrial oil on the heater surface, or/and the odor comes from heat-
resistant enamel.
• When heang up, the heater can enhance the odors present in the air, even if their
source is not the sauna itself or the sauna heater. Such sources, for example, can be
surfaces treated with paint, oil, glue and other materials.
Troubleshoong methods:
• Stoke the heater in accordance with paragraph 2.3.
• Select appropriate materials for treatment of the surfaces in the sauna; use them in
accordance with the applicaon instrucons.
2) Fault: The sauna room is not heang up.
Possible cause:
• The sauna room is too large for the heang capacity of the heater.
• Thermal insulaon of the room is not in compliance with the requirements.
• Insucient chimney dra.
• Low quality or wet combuson material.
• Blockage in the chimney or ue channels of the heater.
Troubleshoong methods:
• Check that the heater capacity matches the size of the sauna (secon 1).
• Check the thermal insulaon of the room (secon 1).
• Check combuson material for compliance (paragraph 2.4).
• Perform maintenance (paragraph 2.8).
3) Fault: The stones in the stone heater do not heat up.
Possible cause:
• The sauna room is too small for the heang capacity of the heater. The room is heang
up faster than the stones.