Grill'D Aurora - Installation Manual

42
• Insucient chimney dra.
• Low quality or wet combuson material.
• Blockage in the chimney or ue channels of the heater.
• The stones are laid incorrectly.
Troubleshoong methods:
• Check that the compliance of the heater capacity against the sauna size (secon 1).
• Check combuson material for compliance with the requirements (paragraph 2.4).
• Perform maintenance (paragraph 2.8).
• Inspect the stone heater for compliance with the requirements (paragraph 2.5).
Remove stone chips and replace them with intact stones. Replace the stones with
diameters less than the ones specied in Table 1 with larger ones.
4) Fault: The operang mode of the heater cannot be controlled during wind /heater ring/
low chimney dra during operaon. Smoke partly escapes through the rebox door. Smoke
enters the sauna.
Possible cause:
• Blockage in the chimney or ue channels of the heater.
• The chimney height is not sucient or the chimney is located next to a high obstacle.
• There is cold air in the chimney; the chimney has not heated up.
• Low quality or wet combuson material.
• The chimney is installed incorrectly.
Troubleshoong methods:
• Perform maintenance (paragraph 2.8).
• Extend the chimney stack height.
• Insulate the chimney stack with a non-combusble heat-insulaon material.
• Select a heat-insulated chimney stack.
• Remove ash from the ash drawer.
• Check combuson material for compliance with the requirements (paragraph 2.4).
• Ensure supply of a sucient volume of combuson air.
• Check the correctness of chimney installaon and/or compliance with the
manufacturer’s requirements; trust the installaon and disassembly of the chimney
only to qualied specialists.
3. INSTALLATION MANUAL
3.1. Before commencing installation of the heater
IMPORTANT! Make sure that all safety distances around the heater are observed. There
shall be no electrical appliances, cables, meltable and ammable materials within the
safety distances. Consider the safety distances from the chimney during installaon!
• The heater shall be installed in compliance with all local rules, including those referring to
European and naonal standards.
• The chimney stack for the heater shall be individual, not joint combined for several
appliances.
• For more informaon about re safety requirements, please, address the local re
department.
• Check the availability of all the heater component parts. Make sure that all the heater
bolted connecons are ghtened.