GB
25
Assembly
Disconnect the plug before any
work on the equipment. There is a
risk of injury.
Assembling the Curved Handle
Install lower bar:
Insert the bottom bars (4) into
the brackets provided for this
on the right and left of the
equipment casing. Screw them
in place with one cross-head
screw (6) in each.
Install curved handle:
1.
Use the screws and washers from
the package as well as the top
clamping levers (3) to mount the
curved handle (1) on the right and
left ends of the bottom bar (4).
Two positions are possible.
2. Turn the clamping levers (3)
clockwise.
3.
Lock the clamping levers (3) by
pushing them towards the bar (4).
Clamping levers to be tightened
and contacting the bar such that
they clamp at average force.
Otherwise you may have to
tighten (turn clockwise) or loos-
en them (turn anticlockwise).
Clip on the cable hook:
Clip on the cable hooks (
13) to the bar to fasten the
connection cable ( 15).
Installing the grass catcher
Assemble the grass catcher:
Clip the rubber lip of the grass
catcher net (19) into the hard
plastic tray of the grass catcher
(7).
Insert the linkage tubes (19) into
the grass catcher net (20). Make
sure to fully insert the tubes (see
ill. detail).
The tube bows t into the
groove (21) at the bottom of the
grass catcher
Pull the plastic straps (22) over
the linkage tubes (20).
Use the screws and washers
(23) from the package to mount
the linkage tubes (20).
Operation
Attention: Do not operate the ap-
pliance until the collision guard
and grass catcher are fully in-
stalled. Risk of injury!
Mounting / removing the grass
catcher
1. Lift the collision guard (5).
2. Place the grass catcher (7) on the
mounting bracket (24) provided at
the back of the lawn mower.
3. Lower the collision guard (5)
onto the grass catcher (7) - it
will keep it in place.
4.
To remove the grass catcher (7),
lift the collision guard (5) and un-
hook the grass catcher from the
mounting bracket. Flap down the
collision guard to the housing.
On emptying the grass catcher
also refer to section “Disposal/en-
vironment”.
Adjusting the Cut Height
Switch o the equipment, discon-
nect the plug and wait for the blade
to stop. There is a risk of injury.
To Next Page
Loading...
Need help?
General
