GB
30
Trouble Shooting
Problem Possible Cause Fault Fixing
Equipment does not
start
Power is o
Check the socket, cable, wire and
plug and have any repairs carried
out by an electrician
Defective start lever (
2) or release button (
16)
Repair by customer services
Worn carbon brushes
Defective motor
Grass too long
Set a greater cut height. Lift the
front wheels slightly by pressing
down on the handle bar.
Motor stops Blockage by foreign object Remove the foreign object
Result unsatisfactory
or motor labours
Cut height too low Set a higher cut height
Blade ( 25) blunt
Have the blade sharpened or re-
place it
Blade area blocked Clean the equipment
Blade ( 25) assembled
incorrectly
Install the blade correctly
Blade fails to turn
Blade ( 25) blocked by
grass
Remove the grass
Blade screw ( 26) loose
Tighten the blade screw
Strange noises, rat-
tling or vibrations
Blade screw ( 26) loose
Tighten the blade screw
Blade ( 25) damaged
Replace the blade
Replacement parts/
Accessories
Spare parts and accessories
can be obtained at
www.grizzly-service.eu
If you do not have internet access, please
contact the Service Centre (see “Grizzly
Sercice-Center”). Please have the order
number mentioned below ready.
Spare blade ............................. 91095738
Grass catcher ........................... 91095751
To Next Page
Loading...
Need help?
General
