-34-
Model G0621X (Mfd. Since 07/17)
Blade Selection
(Metal Cutting)
Copper
Alloy
229~482
(70) (147)
203~413
(62) (65)
229~482
(70) (147)
220
(67)
220~534
(67) (163)
203
(62)
220~534
(67) (163)
321
(98)
180~220
(54) (67)
95~213
(29) (65)
180~220
(54) (67)
65~85
(20) (26)
180~220
(54) (67)
75~118
(25) (36)
180~220
(54) (67)
108~225
(33) (75)
196~354
(60) (108)
203
(62)
196~354
(60) (108)
150~203
(46) (62)
Aluminum
Alloy
Thin
Tube
Angle
Steel
Carbon
Alloy
Speed FPM
(M/Min)
Speed FPM
(M/Min)
Speed FPM
(M/Min)
Speed FPM
(M/Min)
Material
TOOTH SELECTION
CUTTING SPEED RATE RECOMMENDATION
Material Material Material
Tool Steel
Mold Steel
High-Speed
Tool Steel
Alloy
Steel
Water
Hardening
Tool Steel
Stainless
Tool Steel
High-Speed
Tool Steel
Free Machining
Stainless Steel
Gray
Cast Iron
Ductile
Austenitic
Cast Iron
Malleable
Cast Iron
Plastics
Cold-Work
Tool Steel
Hot-Work
Tool Steel
Oil-Hardening
Tool Steel
50
2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 192½ 3½
75 100 150 200 250 300 350 400
2/3
2/3
2/3 1.4/2.5
1.4/2.5
1.5/.8
1.5/.8
3/4
3/4
3/4
4/6
4/6
5/8
450
mm
inch
Material Width/Diameter
Material Shapes
Teeth Per Inch Variable Pitch Blades
Figure 38. Blade selection and speed chart.
Selecting the right blade for the job depends on
a variety of factors, such as the type of material
being cut, hardness of the material, material shape
machine capability, and operator technique.
The chart below is a basic starting point for choos-
ing blade type based on teeth per inch (TPI) for
variable tooth pitch blades and for standard raker
type bi-metal blades/HSS blades. However, for
exact specifications of bandsaw blades, contact
the blade manufacturer.
To select the correct blade TPI:
1. Measure the material thickness. This mea-
surement is the length of cut taken from
where the tooth enters the workpiece, sweeps
through, and exits the workpiece.
2. Refer to the "Material Width/Diameter" row
of the blade selection chart in Figure 38 and
read across to find the workpiece thickness
you need to cut.
3. Refer to the "Material Shapes" row and find
the shape and material to be cut.
4. In the applicable row, read across to the right
and find the box where the row and column
intersect. Listed in the box is the minimum
TPI recommended for the variable tooth pitch
blades.
5. The "Cutting Speed Rate Recommendation"
section of the charts offers guidelines for vari-
ous metals, given in feet per minute (speed
FPM) and meters per minute in parenthesis.
Choose the speed closest to the number
shown in the chart.
To Next Page
Loading...
Need help?
General
