5.
6.
Step 5
7.
Steps 5–6
If the sandpaper strip comes loose during
operation, it could cause the workpiece to
bind and kickback at the operator, which
could result in serious personal injury.
Always make sure the sandpaper strip is
properly installed and firmly secured by the
clamping devices before connecting the
sander to power.
8.
Figure 20
Important: When wrapping the strip onto
the drum, a minimum
1
⁄8" gap between the
edges may be necessary, but do not overlap.
Additionally, make sure that the strip remains
tight without any slack.
Figure 20.
Figure 19.
4.
Figure 19
9.
Figure 21
Figure 21.
To Next Page
Loading...
Need help?
General
