Grizzly G0858 User Manual

Table of Contents
INTRODUCTION ............................................... 2
Contact Info.................................................... 2
Machine Differences ...................................... 2
Manual Accuracy ........................................... 2
Identification ................................................... 3
Controls & Components ................................. 4
Machine Data Sheet (G0855) ........................ 6
Machine Data Sheet (G0856) ........................ 8
SECTION 1: SAFETY ..................................... 10
Safety Instructions for Machinery ................ 10
Additional Safety for Jointers ....................... 12
SECTION 2: POWER SUPPLY ...................... 13
SECTION 3: SETUP ....................................... 15
Needed for Setup ......................................... 15
Unpacking .................................................... 15
Inventory ...................................................... 16
Hardware Recognition Chart ....................... 17
Cleanup ........................................................ 18
Site Considerations ...................................... 19
Assembly ..................................................... 20
Knife-Setting Jig (G0855) ............................ 24
Dust Collection ............................................. 25
Test Run ...................................................... 25
Tightening Belt ............................................. 26
Disabling & Locking Switch.......................... 26
SECTION 4: OPERATIONS ........................... 27
Operation Overview ..................................... 27
Stock Inspection & Requirements................ 28
Squaring Stock............................................. 29
Surface Planing............................................ 30
Edge Jointing ............................................... 31
Bevel Cutting................................................ 32
Rabbet Cutting ............................................. 33
Setting Depth of Cut .................................... 34
SECTION 5: ACCESSORIES ......................... 36
SECTION 6: MAINTENANCE ......................... 38
Schedule ...................................................... 38
Cleaning & Protecting .................................. 38
Lubrication ................................................... 39
SECTION 7: SERVICE ................................... 40
Troubleshooting ........................................... 40
Setting/Replacing Knives (G0855) ............... 42
Rotating/Replacing Spiral Cutterhead
Inserts (G0856) ............................................ 45
Adjusting Gibs .............................................. 46
Checking/Adjusting Table Parallelism ......... 47
Setting Outfeed Table Height ...................... 48
Setting Fence Stops .................................... 49
Calibrating Depth-of-Cut Scale .................... 51
Tensioning/Replacing V-Belt........................ 52
Checking/Aligning Pulleys............................ 53
Checking/Adjusting Cutterhead Guard ........ 54
SECTION 8: WIRING ...................................... 55
Wiring Safety Instructions ............................ 55
Wiring Diagram ............................................ 56
SECTION 9: PARTS ....................................... 57
Fence & Cutterhead ..................................... 57
Tables, Base, Stand & Motor ....................... 58
Labels & Cosmetics ..................................... 61
WARRANTY & RETURNS ............................. 65
Like all machinery there is potential danger
when operating this machine. Accidents
are frequently caused by lack of familiarity
or failure to pay attention. Use this machine
with respect and caution to decrease the
risk of operator injury. If normal safety pre-
cautions are overlooked or ignored, seri-
ous personal injury may occur.
No list of safety guidelines can be com-
plete. Every shop environment is different.
Always consider safety first, as it applies
to your individual working conditions. Use
this and other machinery with caution and
respect. Failure to do so could result in
serious personal injury, damage to equip-
ment, or poor work results.

Grizzly G0858 Specifications

General

Brand	Grizzly
Model	G0858
Category	Power Tool
Language	English