Grizzly G0858 User Manual

Model G0855/G0856 (Mfd. Since 02/19)
-39-
Table Ways
Oil Type .... Grizzly T27914 or ISO 68 Equivalent
Oil Amount ...........................................1–2 Drops
Lubrication Frequency .... Monthly, or As Needed
Lower infeed and outfeed tables to access ways.
Clean ways with mineral spirits and shop rags,
allow to dry, then lubricate with light machine oil
at top of each way (see Figure 48). Move tables
up and down to distribute oil. Wipe off excess oil.
Lubrication
Leadscrews
Oil Type .... Grizzly T27914 or ISO 68 Equivalent
Oil Amount ...........................................1–2 Drops
Frequency ....................... Monthly, or As Needed
Clean leadscrews (see Figure 47) with mineral
spirits and shop rags, allow to dry, then lubricate
with light machine oil. Wipe off excess oil.
Since all bearings are sealed and permanently
lubricated, simply leave them alone until they
need to be replaced. DO NOT lubricate them.
It is essential to clean components before lubri-
cating them because dust and chips build up on
lubricated components and make them hard to
move. Simply adding more grease to them will not
yield smooth moving components.
Item(s) Needed: Qty
Pump-Type Oil Can ........................................... 1
Mineral Spirits .................................... As Needed
Clean Shop Rags .............................. As Needed
Lubrication
Fence & Carriage
Oil Type .... Grizzly T27914 or ISO 68 Equivalent
Oil Amount ...........................................1–2 Drops
Lubrication Frequency .... Monthly, or As Needed
Clean fence pivot points and carriage ways (see
Figure 46) with mineral spirits and shop rags,
allow to dry, then lubricate with light machine oil.
Wipe off excess oil.
Figure 48. Location to lubricate table ways.
Figure 46. Fence and carriage lubrication
locations.
Figure 47. Leadscrew lubrication locations
(handwheel removed for clarity).

Grizzly G0858 Specifications

General

Brand	Grizzly
Model	G0858
Category	Power Tool
Language	English