-20-
Model G0939/G0940 (Mfd. Since 12/20)
To test run machine:
1.
Make sure all tools and objects used during
setup are cleared away from machine.
2.
Connect machine to power source.
3. Turn machine ON, verify motor operation,
then turn machine OFF. Motor should run
smoothly and without unusual problems or
noises.
4.
Remove switch disabling key, as shown in
Figure 13.
5.
Try to start machine with paddle switch.
— If machine does not start, switch disabling
feature is working as designed.
Congratulations, test run is now complete!
— If machine starts, immediately turn
machine OFF and disconnect from power.
The switch disabling feature is not working
correctly. This safety feature must work
properly before proceeding with regular
operations. Call Tech Support for help.
Figure 13. Removing key from paddle switch to
disable switch and prevent unauthorized use.
To Next Page
Loading...
Need help?
General
