Grizzly G1024 - Machine Specifications

XVI. MACHINE DATA
GRIZZLY MODEL G1024
3
/4 H.P. SHAPER
Design Type ....................................................................................................................Floor Model
Overall Dimensions:
Table ................................................................................................................................15” x 18”
Height From Floor to Top of Fence ..........................................................................................38"
Height to Table From Floor ....................................................................................................34
1
/2"
Length........................................................................................................................................24"
Width ........................................................................................................................................27"
Weight (Shipping) ..............................................................................................................155 lbs.
Weight (In Place) ..............................................................................................................145 lbs.
Construction:
Table ..................................................................................................................Ground Cast Iron
Fence Assembly ..............................................................................................................Cast Iron
Body Assembly ................................................................................................................Cast Iron
Stand....................................................................................................................Pre-formed Steel
Specifications:
Spindle Travel ..........................................................................................................................3
7
/8"
Spindle Diameter........................................................................................................................
1
/2"
Spindle Length ............................................................................................................................3"
Spindle Capacity under Nuts ..................................................................................................2
3
/8"
Spindle Speed ............................................................................................................10,000 RPM
Table Counterbore ......................................................................................3" Diameter,
3
/8" Deep
Spindle Bearings ................................................................Ball/Shielded and Lubricated-For-Life
Motor:
Type..............................................................................................TEFC Capacitor Start Induction
Horsepower ........................................................................................................................
3
/4 H.P.
Phase / Cycle ..............................................................................................Single Phase / 60 HZ
Voltage ..........................................................................................................................110V/220V
Amps........................................................................................................................................10/5
RPM ........................................................................................................................................3450
Bearings..................................................................................
Shielded and Lubricated-For-Life / Ball
Features:
Fence ..........................................................................................................Both Sides Adjustable
Switch ..............................................................................................................................ON/OFF
Switch ............................................................................................................................Reversible
Starting Pins ....................................................................................................................Standard
Protective Cover For Freehand Work..............................................................................Standard
Spindle Lock ....................................................................................................................Standard
Miter Gauge ....................................................................................................................Standard
Specifications, while deemed accurate, are not guaranteed.
- 28 -