Model T32720 (Mfd. Since 06/21)
-13-
Assembly
The machine must be fully assembled before it
can be operated. Before beginning the assembly
process, refer to Needed for Setup and gather
all listed items.
To assemble machine:
1.
Loosen torque adjustment knob all the way
(see Figure 7).
Figure 7. Location of torque adjustment knob.
2.
Turn machine on its side to access inside of
base and remove foam packaging.
3.
Push motor down as far as it will go (see
Figure 8).
4.
Tighten torque adjustment knob until cap on
shaft contacts motor (see Figure 8).
Torque Adjustment
Knob
Figure 8. Torque adjustment knob tightened so
cap contacts motor.
Cap
Motor
Direction to Push Motor
Site Considerations
Figure 6. Minimum working clearances.
Electrical Connection
=
15½"
18½"
Children and visitors may be
seriously injured if unsuper-
vised around this machine.
Lock entrances to the shop
or disable start switch or
power connection to prevent
unsupervised use.
Workbench Load
Refer to the Machine Data Sheet for the weight
and footprint specifications of your machine.
Some workbenches may require additional rein-
forcement to support the weight of the machine
and workpiece materials.
Consider anticipated workpiece sizes and addi-
tional space needed for auxiliary stands, work
tables, or other machinery when establishing a
location for this machine in the shop. Below is
the minimum amount of space needed for the
machine.
Placement Location
To Next Page
Loading...
Need help?
General
