EasyManuals Logo

Ground Zero DSP Series User Manual

Ground Zero DSP Series
22 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
- 4 -
Required parts and tools for the installation
screwdriver
electric drill, 3 mm / 0.12“ carbide drill bit
mounting screws
IMPORTANT!
Disconnect the vehicle battery before starting the installation! (Note the vehicles operating manual)
Never drill any holes into the fuel tank, brake pipes, wiring or any other sensitive parts of the vehicle!
Keep the installed wires away from any sharp edges!
Selecting a mounting position
Select a suitable location that is convenient for mounting, is accessible for wiring and has an ample room for air circulation and cooling.
The unit must not be covered or mounted close to heat emitting objects. Because of the high operation temperature (up to 80°C), it is
important to ensure sufficient distance to any heat-sensitive object. Especially the distance between GZDSP 4.60ISO and any plastic part or
electronic component should be at least 3 cm (1.18”).
Mounting the Unit
You may use the unit as a template to mark the mounting holes, then remove it and drill the marked holes. Finally mount the unit with the
mounting screws.
Caution
Choose a mounting position where all electric wires are protected from being damaged by sharp edges, heat or other conditions. +12 Volt
DC electrical connections must be fused on the battery side. Make sure your head-unit and all other devices will remain turned off while
connecting parts of the system. If it is necessary to replace any fuse make sure to use only an equivalent one. Using inferior fuses may cause
serious damage to your unit, wiring or even your cars electric. Any kind of damage traced back on disregard of these notes will not be
covered by the warranty!
WARNING!
High powered audio systems in a vehicle are capable of generating "Live Concert" levels of sound pressure.
Continued exposure to excessively high volume sound levels may cause hearing loss or damage. Also, operation of a
motor vehicle while listening to audio equipment at high volume levels may impair your ability to hear external
sounds such as horns, warning signals or emergency vehicles! This may lead to potential traffic hazards. In the
interest of safety, consumer electronics recommends listening at lower volume levels while driving.

Other manuals for Ground Zero DSP Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Ground Zero DSP Series and is the answer not in the manual?

Ground Zero DSP Series Specifications

General IconGeneral
BrandGround Zero
ModelDSP Series
CategoryComputer Hardware
LanguageEnglish