Grow GM65 - Tail; Cut out Data

19
Change CODE ID of Data Matrix Change CODE ID of limited PDF417
6.4 Tail
Open this function to help system quickly distinguish current decoding results.
Scan “Add tail” to open this function,if read success, there will be tail on the end of decode data.
Close tail Add tail “CR”
Add tail “TAB” Add tail “CRLF”
6.5 Cut out Data
Open to output part of data.
[Data] is composed of [Start] + [Center] + [End]
Character length of “start” and “end” can be changed
Output whole data Output Start part
Output End Part Output Center part
Change length of [Start]-M
Scan “ Change M” code and “data edition” code to change length of [Start], max 255 characters