12
11 Shinelink-X lights correct, but inverter offline
Are all the lights on correctly, but is the inverter still offline? Then check that the correct
serial number is associated with the account. With the Shinelink-X, the serial number of the
Shinelanbox (base station) must be linked and not that of the RF-stick (dongle).
12 Shinelan-X
13 Requirements and preparation
Supplies:
• Shinelan-X
• A modem or router with a free network port
Preparations:
It is important that the inverter is switched on. Most Growatt inverters only turn on when the
solar panels are connected and they provide sufficient power. This means that the
configuration can only be done in sufficient daylight.
14 Data logger status and malfunctions
The Shine lan-X is connected
to the inverter.
Connect the network cable .
The Shinelan-X is connected
to the inverter, but is not
connected to the router.
Make sure network cable is connected. The Shinelan-
X has a 10Mb ps connection, check if your equipment
is compatible with that.
The Shinelan-X is connected
to the inverter and connected
to the router, but is not
connected to the server.
The connection to the server is blocked. This may be
caused by a firewall setting on the Internet modem.
Turn off the firewall or open ports 5279 and 5280.
The Shinelan-X is connected
to the inverter and connected
to the router and server.
The Shinelan-X is configured correctly.
15 Link data logger to account
If the data logger has not previously been linked to your account, you can perform the link
via the website https://server.growatt.com/. If you do not yet have an account, you can
register, see sections 6.2 and 6.3.
Linking the data viewer via the website:
To Next Page
Loading...
