Growatt SPF 6000 ES PLUS - Operating Mode Description; Standby mode; Power saving mode; Fault mode

23
① AC input power in Watts
② Inverter temperature
③ Load power in Watts
④ Left：PV1 input power in Watts
Right：PV2 input power in Watts
⑤ Battery percentage
⑥ Warning or Fault code
Firmware version
(CPU1: 040-00-b21; CPU2:041-00-
b21)
Time
(15:20:10, December 15, 2018)
Operating Mode Description
Operation mode
Description
LCD display
Standby mode / Power
saving mode
Note: *Standby mode: The
inverter is not turned on yet
but at this time, the inverter
can charge battery without
AC output.
*Power saving mode: If
enabled, the output of
inverter will be off when
connected load is pretty low
or not detected.
No output is
supplied by the
unit but it still
can charge
batteries.
Charging by utility and PV
energy.
Charging by utility
Charging by PV energy
No charging
Fault mode
Note:
*Fault mode: Errors are
caused by inside circuit error
or external reasons such as
over temperature, output
short circuited and so on.
PV energy and
utility can
charge batteries.
Charging by utility and PV
energy
Charging by utility
Charging by PV energy
No charging